WATCO Clear Crystal Clear Lacquer Gloss Quart (946ml)

Watco Clear Crystal Clear Lacquer Gloss 1 Quart (946ml)WATCO Lacquer Clear Wood Finish is the finest brushing lacquer available. WATCO Lacquer fills in the pores of most wood types eliminating the need for wood filler. Apply to furniture, doors, cabinets and paneling for a crystal-clear, durable wood finish. Dries in 30 minutes and does not require sanding between coats. Please read product labels for additional directions and precautions before usingFast-dryingDurable protectionIdeal for use on furniture, doors, cabinets and paneling; not recommended for floors or exterior surfacesFormulated for a higher clarity finish than polyurethaneDries to the touch in 1 hour and covers up to 290 sq ftEliminates the need for wood filler and protects against scratches; no need to sand between coatsDries to a crystal-clear gloss with a lasting durable finishApply to furniture, doors, cabinets and panelingDries in 30 minutes and does not require sanding between coatsFor Best ResultsApply with good quality natural bristle brush. Use adequate ventilation at all times.Do not apply in direct sunlight.Apply only when the air and surface temperatures are between 55-90F (13-32C) and the relative humidity is below 85%.If applying over white or pastel paints or stains, test in an inconspicuous area before beginning.Testing is important when applying over paints or stains as an undesired appearance may occur when these products are topcoated with a lacquer finish.BRUSHStir thoroughly before and during use. To prevent bubbles in the finish, DO NOT SHAKE, over brush, or apply with a roller.Apply using a good quality bristle brush or applicator. Allow the finish to dry 2 hours and then recoat. Recoat only when the previous coat has dried clear and feels hard.If any coat has dried more than 6 hours, lightly sand with 220 grit sandpaper before recoating to avoid brush marks.Apply additional coats following directions above.A minimum of 3 coats is recommended.Allow finish to dry 24 hours before light use. Allow 7 days before subjecting the surface to normal usage.