BOND IT ANCHOR BOND

is a high-strength, two-part polyester chemical anchoring resin designed to provide secure, permanent fixings in a wide range of construction materials. Supplied in a convenient twin-component cartridge, it mixes automatically through the supplied nozzle to create a rapid-curing, high-performance bond.

Unlike traditional expansion anchors, Anchor Bond distributes the load evenly throughout the fixing point, reducing stress on the surrounding material. This makes it ideal for close-to-edge installations and applications where maximum holding strength is required.

Suitable for use in both solid and hollow substrates, it delivers a durable fixing that is resistant to water, vibration, and many common chemicals once fully cured.

• High-strength polyester chemical anchoring resin

• Two-part system with automatic mixing nozzle

• Fast curing for quick installation

• Suitable for solid and hollow base materials

• Waterproof after curing

• Resistant to vibration and many chemicals

• Excellent load distribution

• Ideal for close-to-edge fixing applications

• Easy to apply using a standard cartridge gun

• Grey finish

• Threaded rods

• Anchor bolts

• Studs

• Wall ties

• Starter bars

• Reinforcing bars

• Large screws

• Railings

• Gates

• Steel framework

• Satellite dishes

• Fire surrounds

• Pipe brackets

• Lighting fixtures

• Heavy-duty shelving

• Concrete

• Brick

• Masonry

• Natural stone

• Aerated concrete blocks

• Hollow blocks (when used with a suitable sleeve or sieve)

Typical Curing Times (Approx. at 20C)

• Gel Time: 5 minutes

• Load Time: 70 minutes

• Full Cure: 2 hours

Curing times will vary depending on temperature.

• Type: Two-part polyester chemical anchor

• Colour: Grey

• Cartridge Size: 310ml

• Application Temperature: Best applied in normal construction temperatures

• Storage: Store between 5C and 25C in a cool, dry place

• Shelf Life: Up to 12 months in unopened packaging

Directions for Use

1. Drill the correct diameter hole to the required depth.

2. Thoroughly clean the hole to remove all dust and debris.

3. Fit the mixing nozzle and dispense a small amount until an even grey colour appears.

4. Fill approximately half the hole with resin.

5. Insert the threaded rod or fixing while slowly twisting.

6. Allow the resin to cure fully before applying any load.

Ideal Applications

Perfect for professional builders, contractors, engineers, installers, and DIY users requiring a strong, permanent fixing for structural and heavy-duty applications where conventional wall plugs or expansion anchors are not suitable.